2005 and 2008 Ford Mustang Sequential / Chase Unit Installation Instruction

2005 and 2008 Ford Mustang Sequential / Chase Unit Installation Instruction~ How to install Butt connectors and Male push on connectors: Strip wire (or wires if more than one) about a half inch. Twist the copper strands together then insert into connector and crimp with wire crimpers. Please look at pictures above for examples. How to install T-tap connectors: Place wire into the “V” opposite side of the metal “V”. Now fold the T-tap over and squeeze together with pliers until T-tap locks and stays together. NOTE: The T-tap will pierce the wires insulation making contact with the wire inside. Preparation : Make sure all turn signal lights work before beginning installation. If you have a light that’s burned out replace it because it could be misleading later on and cause trouble shooting issues. Inside of the trunk remove rear trim panel to expose taillight wires and retaining nuts. Remove the three 11mm nuts on each taillight, unplug each Grey plug, then remove taillight from car, and place them on a workbench for light socket replacement. Connecting New light socket; Same for both sides. Locate the light socket that is closest to the license plate. This socket has two Black wires and one Blue/ Green stripe wire. Cut all three wires about an inch away from the light socket, place light bulb in new light socket and discard old light socket. Now strip all three wires on the Harness. NOTE: Some harnesses only have one Black wire. Reconnect the Grey plug to main harness. Now with the hazard lights flashing cut one of the Red/ White stripe wires halfway between the Grey plug and the Black rubber grummet. Note which light stopped flashing. Note: it will be either the middle or the outboard light that will stop flashing. Connect unit to passenger side taillight, inside the trunk using the wires between the Grey plug and the Black rubber grummet. Using a T-tap and MALE PUSH ON connector, connect the Red/ White stripe wire that was cut above and still connected to the Black rubber grummet to the Grey wire (unit).